Search results

Hello, Today I had the pleasure of removing a perfectly performing cylinder (78/80) from my Franklin 165 because the helicoil backed out as I was removing a spark plug. The cylinder will be on the way to Greg tomorrow. Anyway my question is this. It has been a long time since this propeller has...

I have been using AeroShell 100 in my Franklin 165. Is anyone using 100plus? Are the additives in it a good or bad thing for this engine? Also I see in the manual 520 degrees for max CHT using the spark plus sensor. What would be the max CHT using the screw in probes and what would be max EGT...

Hello, I know this has been discussed in several threads but I can't seem to pull the info together. I am again trying to figure out what to do with my brake master cylinders. I have Cleveland's with the old Scott masters. Also all the lines are -3 in size. I see some have put in new master...

Hello, Does anyone have the pin outs for the Terra TXN920 NavCom? Thanks, Kevin

Hello, On my 14-13 the fabric is glued around the sides and top of the windshield. Some of this is coming loose. Is it correct that it is just glued down onto the Plexiglas or should there also be some kind of trim piece on it? Thanks, Kevin

There are it seems a zillion part numbers for the Bendix harnesses. Does anyone know the correct one for a Franklin 165? Thanks, Kevin

I am not getting much cabin heat. In fact it is warmer with it off then on. I looked in the parts catalog and it appears that I don't have the standard exhaust and heat muff setup. I have straight 3 into one pipes with muffs but the parts book shows what looks like round mufflers with bigger...

The gap from the wing root to the fuselage on my 14-13 is covered with fabric but evidently this is supposed to have a removable access cover over it so you can inspect the spar ends and get to the fuel tank lines. Is this correct? If so does anyone have a set of these covers? Kevin

Has anyone used the Real Gaskets on their Franklin push rod tubes? Are they any better them the original? Kevin

I am looking for the three bolts that hold the valve rockers to the head on a Franklin 165. Mine are bent on one cylinder. Does anyone have any or know who does? Thanks, Kevin

Does anyone have a part number and source for the gascolator gaskets before I go cut my own? Thanks, Kevin

Hi all, Can anyone tell me where the ground wire on the left fuel sender is run to? Thanks, Kevin

Does anyone sell a cylinder base nut wrench for the Franklin or is everyone modifying their own? Kevin

Hi all, Has anyone gotten approval for Capacitive fuel probes in the Cruisair? Thanks, Kevin

I just bought a 14-13. I am another Ercoupe covert (Hi Tim). The tops of the control yokes have been cut off. Anyone know where I could find another pair? Thanks, Kevin