blimpy
New member
Drill a tiny hole to drain leaky float.
Use heat gun to really dry out the float.
Seal hole with solder.
Submerge in hot water to test.
wipe away any bubbles, then look for bubbles due to leak.
Turn over .. and try again.
When satisfied.. set float levels , check resistance F and E and when all is well,
re-install.
See long post on service/repair/inspection.
Use heat gun to really dry out the float.
Seal hole with solder.
Submerge in hot water to test.
wipe away any bubbles, then look for bubbles due to leak.
Turn over .. and try again.
When satisfied.. set float levels , check resistance F and E and when all is well,
re-install.
See long post on service/repair/inspection.